Recommended Dimensions of Passenger Lifts and Service Lifts
#1

Recommended Dimensions of Passenger Lifts and Service Lifts

As per Clause 5.10.3.1 of  section 5A of Part-8 of NBC 2016
The outline dimensions of lift shaft, machine room, pit depth, overhead and raw door opening size for lifts

[Image: image-4.png]
[Image: image-5.png]

NOTE 

1 All dimensions given above for lifts having two panel telescopic doors (2P TSPD) with counterweight at side, are recommended dimensions primarily for architects and building planners. Any variations mutually agreed to between the manufacturer and the purchaser are permitted. However, variation in: 

a)car inside dimensions shall be within the maximum area limits specified in accordance with accepted standards [8-5A(6)]. 

b)entrance width on higher side is permitted. 

c)entrance width on lower side is permitted up to 100 mm subject to minimum of 700 mm. 
d)2 Car depth of 2 100 mm may be considered in residential/commercial buildings, where use of only ambulance stretcher is envisaged. The hoist-way depth maybe reduced accordingly.

to read more ... http://frontdesk.co.in/building-services...portation/
Reply


Messages In This Thread
Recommended Dimensions of Passenger Lifts and Service Lifts - by sandeep jain - 06-02-2019, 07:55 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)