AAC Manufacturing Process
#1

AAC Manufacturing Process

Unlike most of the other concrete applications, AAC is produced using no aggregate larger than sand. Quartz sand, calcined gypsum, lime (mineral), cement and water are used as a binding agent. Aluminum powder is used at a rate of 0.05%–0.08% by volume (depending on the pre-specified density). In some countries, like India and China, fly ash is generated from thermal power plants with the use of 50-65% silica content on an aggregate.

When AAC is mixed and cast in forms, several chemical reactions take place that give AAC its light weight (20% of the weight of concrete) and thermal properties. Aluminum powder reacts with calcium hydroxide and water to form hydrogen. The hydrogen gas foams and doubles the volume of the raw mix creating gas bubbles up to 3mm in diameter. At the end of the foaming process, the hydrogen escapes into the atmosphere and is replaced by air.

When the foams are removed from the material- it is solid but still soft. It is then cut into either blocks or panels and placed in an autoclave chamber for 12 hours. During this steam pressure hardening process, when the temperature reaches 190° Celsius (374° Fahrenheit) and the pressure reaches 8 to 12 bars, quartz sand reacts with calcium hydroxide to form calcium silica hydrate, which gives AAC its strength along with other unique properties. Because of the relatively low temperature used, ACC blocks are not considered fired brick, but a lightweight concrete masonry unit. After the autoclaving process, the material is ready for immediate use on the construction site. Depending on its density, up to 80% of the volume of an AAC block is air. AAC's low density also accounts for its low structural compression strength. It can carry loads of up to 8 MPa (1,160 PSI), approximately 50% of the compressive strength of regular concrete.

[Image: acc8.jpg]

RICHA INDUSTRIES LIMITED
Plot No 29, DLF Industrial Area, PH-II Faridabad -121003, Haryana
Ph: +91-129-4009262 
Reply


Messages In This Thread
AAC Manufacturing Process - by Richa Industries - 08-21-2014, 08:51 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)